See how Shiftt works →
Shiftt is live
The Failure Files · Volume 6

Six more.
Find it before you fit it.

Component, service history, symptom, photo. You pick what killed it. Then you find out if you're right. Built by a maintenance engineer, for maintenance engineers.

Score 0 / 0
Motor overheating at low speed Case 31
Inverter driven motor · Slow running mixer

Motor trips on its thermistors during the long slow batches, fine on the fast ones. New motor, same trips. Current is well under the nameplate.

Under nameplate current, new motor, still overheating. Why?

Hydraulic cylinder creeping under load Case 32
Hydraulic cylinder · Lift table

Table creeps down with a load on it, a few millimetres a minute. Cylinder resealed, then replaced. Still creeps.

New cylinder, same creep. Where's the oil going?

Encoder cable beside motor cables Case 33
Incremental encoder · Cut to length line

Cut lengths drift and the drive logs encoder faults, worst when the whole line is running. New encoder, new cable pulled in along the old route. Same faults.

New encoder, new cable, still losing counts. What's corrupting the signal?

Every one of these was a call-out someone had to cover

Sickness, a shutdown, a Friday night with a line down and nobody spare. That's the gap Shiftt fills. Vetted engineers, the engineer's rate plus a flat 10%, no agency margin.

See how it works →
Steam heat exchanger stall Case 34
Steam heat exchanger · Process water heater

Outlet temperature hunts and the exchanger bangs at low demand. Fine at full load. New control valve and new steam trap, same again.

New valve, new trap, only misbehaves at low load. Why?

Motor terminal box with clamp meter on one phase Case 35
Three phase motor · Air compressor

Motor runs hot and one phase draws 18% more current than the other two. Motor rewound, same imbalance. The three supply voltages look about the same on the meter.

Freshly rewound, still one heavy phase. Is it the motor?

Worn V belt pulley grooves Case 36
V belt drive · Hammer mill

Belts squeal on start and wear through their sides in weeks. Replaced as a matched set, tensioned with a gauge, pulleys laser aligned. Same again.

Matched set, right tension, aligned. What's eating them?

Live now

Know your kit?
Shiftt is live.

Shifts are being posted and picked up now. Engineers set their own rate and keep all of it. Employers get vetted cover fast, on a flat 10%, with no recruiter in the middle.

Join Shiftt now →

The photographs are AI-generated illustrations. The failure modes, the evidence and the diagnoses are real, the kind of thing you see on the floor every week.